The Most Trusted Community in Walleye Fishing | est. 1996

  • Latest Pic
    by DW72 on February 26, 2026 at 5:46 pm

    Looking good!

  • High Big Fish
    by DW72 on February 23, 2026 at 9:17 pm

    Dang it. Just write a big long thread on my phone and it didn't post and kicked me out. Very short version. Anyone willing to chat about...

  • Low Lake levels
    by Lucky Duck on February 17, 2026 at 3:32 pm

    I wonder how much the lake levels are going to rise this year after the ice melts. My dock in MArblehead on West Harbor is still down about 24- 30...

  • Is hot waters ramp complete?
    by Squatch on February 12, 2026 at 2:08 am

    Anyone know if they finished the new ramp at hot waters? I know they were doing big project to greatly improve the ramp, just wondered if it was done...

Boat Listings for Sale

1988 Sylvan sportsmaster 21'  | $18,000.00


1988 Sylvan sportsmaster 21 ft
1988 Sylvan sportsmaster 21 ft | Lake Erie
1988 Sylvan sportsmaster 21 ft | Walleye, Bass, Trout, Salmon Fishing Boat
1988 Sylvan sportsmaster 21 ft | 2625 Ridge Rd
1988 Sylvan sportsmaster 21 ft | Gasoline
STATUS: Sold (Boat Sold Fast!)
YEAR: 1988
MAKE: Sylvan
MODEL: sportsmaster
LENGTH: 21' foot

Number of Engines: 2
Engine Hours: 68.6
Fuel Type: Gasoline

Boat Location: 2625 Ridge Rd

1988 Sylvan 21' that was gutted down to the bare keel (floor, consoles, and all floatation material was removed). The exterior of the hull was sanded and then sealed with Gluvit aluminum protector and sealer inside and out.(All exterior peened rivets were intact, just thought extra protection would'nt hurt) and then sprayed with interlux primer and bottom paint. New 3/4" marine grade plywood was installed on main and bow deck and main deck had holes drilled and put in new closed cell expandable foam under entire floor except where I installed a 28gal internal fuel tank. Everything that got reattached ie gunwale, wall panels, consoles. Transom was replaced with a new piece of aluminum and new marine grade plywood and reinforced with a piece of stainless for the motors. Glide Ryde seat bases to ease the rough ride on the water. Didn't like the straight up sylvan windshield so I replaced it with a swept back from a boat junkyard, had to mill some aluminum bars to make it fit. The steering was replaced with Teleflex Hydraulic Steering to accommodate new motors(installed by parma marine). The motors were brand new in 2013 and professionally installed with all new rigging and gauges by Joel at Parma Marine. They are a 115 Evinrude Etec with auto oil injection and auto gauge winterizing with only 68.6 Hours, the kicker is also and evinrude 9.8 w/electric start and separate throttle control but connected to main steering. Humminbird Ipilot Terrova 24V 80lbs thrust 60" shaft, Humminbird 898c used for GPS, Furuno FCV-587 fish finder w/ Airmar 1000 Watt transducer. Four sets of quick disconnect Cisco rod holders ( 2, 4 rod and 2 sets of 3 Trees). Trailer was new in 2015 5S-AC21T5200102TB1 Load Rite that weighs 1140LB. Cant remember boat weight but my old 2003 Envoy pulled it effortlessly. I have all titles ie. boat, main motor and trailer. Boat was never left outside after it was totally rebuilt. Contact me for more pictures if you would like. I set this boat up for Lake Erie Walleye fishing. JUST IN TIME TO GET READY FOR THE FALL BRAWL.